Curved Structural Mechanically Seamed Panels

These panels are designed to be installed over solid substrate or over open framing and require field mechanical seaming during the installation process.

Note: Normally, a factory sealant is installed into the female rib during manufacture. If the panel is to be curved, factory sealant must be omitted and a continuous tape sealer applied on the top of the male leg as the curved panels are installed.

To order panels, click here for our panel order form.
Order Form
Print it out, fill it in, and fax it back to us at
817-293-5039.

Please note that the form will open in a new window or browser tab.

Manufacturer or Profile Capabilities: • MBCI - "Curved BattenLok Panel"
• PETERSEN ALUMINUM - "Curved Tite Loc Panel"
• SOUTHWESTERN ROOFING - "Curved Uniloc Panel"
• ARCHITECTURAL BLDG. COMPONENTS - "Curved 200 SL Panel"
• KNUDSON MFG. - "KR-24 Panel" (2" tall leg)
• UNITED STRUCTURES OF AMERICA - "Sure-Lok Panel"
• ASSOCIATED BUILDING SYSTEMS (Kirby/Gulf States) - "Roof-Lok"

Material Limitations: 24 ga. and 22 ga. Steel or .032 Aluminum

Radius Limitations: 20' or greater (for less than 20' radius, please inquire).

If you have a similar profile you wish to have curved, please contact us to discuss your requirements. We will need sample panels of your profile to test the compatibility of our equipment and your panel profile.

Image of Mechanically Seamed Panel 3D extrusion. Technical drawing of Mechanically Seamed Panel cross section.